Product Overview - LEGRAND C2G C2G30022 Bedienungsanleitung

Dual HDMI HDBaseT + RS232 over Cat Extender Single Gang Wall Plate Transmitter - 4K 60Hz

Product Overview

Front Panel
Transmitter
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 Power LED
Off: No power is applied to the device.
On: The corresponding HDMI input is selected.
2 HDMI IN 1-2
Off: The corresponding HDMI input is not selected.
On: HDBT link is normal.
3 Link LED
Off/Blinking: No HDBT link or link error.
INPUT Selection
4 Press to switch selected input source.
Button
5 HDMI IN 1-2 Connect to an HDMI source using an HDMI cable.
Rear Panel
Transmitter
R P D
EAR ANEL
Connect to an HDBT receiver (such as C2G30015) via a
6 HDBT OUT
Cat 5e/6/6a/7 cable.
Connect to a DC 12V power adapter. The transmitter can
7 DC 12V
be powered by the receiver with PSE module.
Connect to a RS232 enabled device for RS232 pass-
8 RS232
through or connect to a PC for upgrading firmware.
Control the function of RS232 port.
Update: RS232 port is used to update Valens firmware.
9 DIP Switch Pass-through: RS232 port is used to command pass-
through via HDBT port. Users can use API command to
upgrade its MCU firmware in this mode.
2
ESCRIPTION
(us)
(us)