Housing Board Description; Connecting The Power Supply; Connecting The Power Supply (Version Of The Product Not Cabled); Connecting The Power Supply (24Vac/24Vdc) - Videotec MAXIMUS MMX Bedienungsanleitung

4.2 Housing board description

BOARD DESCRIPTION
Connector/ Function
Terminal
J1 Power supply line (24Vac/24Vdc)
J8 Ethernet, PoE+ power supply
SW1 Reset dip-switch
Tab. 1
J1 J8
Fig. 1
6

4.3 Connecting the power supply

Electrical connections must be performed
with the power supply disconnected and
the circuit-breaker open.
When commencing installation make sure
that the specifications for the power supply
for the installation correspond with those
required by the device.
Check that the power supply is adequately
dimensioned.
The product can be powered in
24Vac/24Vdc or via PoE+ (Power Over
Ethernet).
4.3.1 Connecting the power supply
(version of the product not cabled)
4.3.1.1 Connecting the power supply (24Va
c/24Vdc)
Earthing is not planned since the product
does not require it.
The power supply cables should be connected to the
power supply terminal of the housing board (J1, 4.2
Housing board description, page 6).
Perform the connections following the instructions
SW1
reported in the table .
CONNECTING THE POWER SUPPLY
Colour
Power supply 24Vac/24Vdc
Defined by the installer
Defined by the installer
Tab. 2
The power supply terminal can host cables
with the characteristics outlined below.
Nominal section of the cables used: From
0.2mm² (24AWG) up to 1mm² (17AWG).
Terminals
~/+
~/-
MNLCMMXCAM_1905_EN