Foppapedretti JUMBO Montageanweisungen Seite 25

• ENGLISH •
ASSEMBLY - USE
DISASSEMBLY THE HOOD
Unfasten the Velcro flaps and release the back lateral side of the hood from the fastener on the handle
to remove the hood (fig. 35-38).
With a flat-tipped tool, pry open and slightly lift up tab "1" on the front canopy support and, at the same
time, remove the front arch (fig. 36). Repeat on both sides.
With a flat-tipped tool, pry open and slightly lift up tab "1" on the rear canopy support and, at the same
time, remove the rear arch (fig. 37). Repeat on both sides.
STORAGE BASKET
Disassembly: unhook the 3 rear press studs as shown in fig. 45.
Remove the rear harness from the buckles as shown in fig. 46.
Unscrew the screws in the lower part of the footrest fig. 47
Assembly: repeat this process in reverse order.
25