Fuxtec FX-MHP126 Original Bedienungsanleitung Seite 48

Original Bedienungsanleitung FUXTEC FX-MHP126_de_en_fr_ita_rev05
9. GEARBOX CASE
Every 25 operating hours, apply universal grease to the surface of the inner shaft.
Use a lubricant pump to pump in sufficient lubricant until it emerges from the blade attachment.
10. EXHAUST BOX
a. Remove the muffler and use a screwdriver to remove carbon deposits from the exhaust
port. Also remove carbon deposits from the muffler port and cylinder exhaust port. (F13)
(1) Screwdriver
(2) muffler
b. Retighten screws, bolts and brackets.
c. Check that no oil or grease has come between the clutch lining
and the clutch drum and clean with oil and lead-free petrol if
necessary.
11. BLADES
When attaching the Blades, make sure to secure the spacer, washer
and screw, then tighten the nut.
(1) Screw
(2) Washer
(3) Spacer
(4) Nut
- Check the blade and fasteners for tightness, cracks or bending.
- Check the cutters and sharpen with a flat file.
- Keep the cutting blades sharp.
- Round off the back.
- Do not grind with water.
There is no need to adjust the distance between the upper and lower
shearing blades, as this product, due to its design, always guarantees
an optimal distance when assembled correctly. (F11)
48