Important Notes - JBL PROFLORA CO2 STARTER BIO SET Gebrauchsanweisung

JBL PROFLORA CO
7. (
of the double-sided adhesive tape and press the thermal casing and tape firmly to a clean section of the
side pane of the aquarium. Alternatively the thermal casing can be mounted inside the aquarium cabinet
or onto a vertical surface near the aquarium using the screws provided.
JBL PROFLORA CO
8. (
JBL PROFLORA CO
9. (
use the suction cap to fix it in a position near the base of the aquarium where there is a gentle water
current.
JBL PROFLORA CO
10. (
the end of the CO2 hose onto the hose connection of the diffuser
Use the suction cup with a clip to fix the diffuser in a position near the base of the aquarium, where there
is a gentle water current.
JBL PROFLORA CO
11. (
CO2 hose out of the aquarium and cut it off with scissors just above the surface of the water (approx. 10
– 20 cm). Then fit the check valve onto the hose end, paying attention to the direction of flow. The arrow
should point towards the aquarium. Now use the remaining piece of hose to connect the free end of the
check valve to the hose connection on the reaction canister.
The CO
2
40 days per filling.
Handling the hose screw connection on the check valve and reaction canister:
Unscrew the union nut completely and place it on the free hose end. Push the hose end onto the connecting
piece and screw the union nut back on.
Refill:
When no more bubbles are emitting from the diffuser, the substrate in the reaction canister has been used
up. Proceed then as follows:
Pull the hose off the lid of the reaction canister and dispose of its contents in the sewage system. Rinse the
reaction canister in lukewarm tap water. Refill the reaction canister again, as described above, using a new
JBL PROFLORA CO₂ REFILL BIO, available from specialist pet shops.

Important notes:

The system is designed for a room temperature of 21 – 23 °C. In cooler rooms the production of CO
be sufficient. In such a case, the room temperature should ideally be increased.
JBL PROFLORA CO
The
ture, thanks to its thermal casing which transmits the aquarium temperature to the reaction canister.
Should large quantities of the contents of the reaction canister accidentally spill into the aquarium during
operation, this may result in cloudy water and lead to an oxygen deficiency. In such an event, please carry
out a large partial water change. Check that the fertiliser system is operating correctly, in particular that it is
filled to the correct level. Never fill above the upper mark! The reaction canister should always be mounted
securely on a vertical surface using the velcro tape or be positioned inside the thermal casing.
Always keep the reaction canister in an upright position and out of the reach of children!
13 64610 00 0 V01-QuickGuide-BIO CO2-115x170.indd 9 13 64610 00 0 V01-QuickGuide-BIO CO2-115x170.indd 9
ADVANCED BIO SET
2
ADVANCED BIO SET
2
STARTER BIO SET
2
BASIC BIO SET
2
BASIC BIO SET
2
production will start within 24 – 48 hours and will supply your aquarium with CO
ADVANCED BIO SET
2
only): Now remove the protective strip from the other side
only): Position the reaction canister in the thermal casing.
only): Put the air stone inside one end of the CO
JBL PROFLORA CO ADVANCED BIO SET
and
2
JBL PROFLORA CO
JBL PROFLORA CO ADVANCED BIO SET
and
2
set operates largely independently of the room tempera-
UK
hose and
2
only): Push
GLASS MIDI
.
2
only): Feed the
for approx.
2
may not
2
15.07.21 11:53 15.07.21 11:53