Homa Saniquick B100 Originalbetriebsanleitung Seite 27

Installing the lid
1. If the cellular rubber seal is not yet glued in the lid, it
must be glued in according to the following illustra-
tion. For this purpose, the surface of the lid must be
cleaned carefully, e.g. with acetone, so that there are
no dirt or oil residues on it. The cellular rubber strip
can then be glued in place along the inner edge. Fi-
nally, cut the seal to the appropriate length and glue it
in place completely.
³
»
No. Description
Lid
A
Cover adhesive strip
B
Seal
C
Cutting device
D
2. Place the lid with two tabs over the collar of the con-
tainer and then pull the other two tabs over the con-
tainer. The tabs of the lid should now engage over the
collar of the container.
3. To ensure a proper fit of the lid, the supplied tension-
ing strap must now be mounted over the tabs of the
lid on the container.
No. Description
Tank
A
Tensioning strap
B
Lid
C
¿
³
·
»
³
·
»
Installing a pump on Saniquick B
To begin, open the lid of the container pos. 3 by first re-
moving the tension band pos. 2 and then pulling the tabs
of the lid away one by one over the container. The drawing
can be found in the previous chapter under „Installing the
lid". First remove the installation set for the pumps from
the container. To release the installation set from the pres-
sure outlet, pull the blue lever (B).
A
G 1¼" IG
Proceed as follows to attach the installation set to the
pump.
1. Only for TP28 and TCV408:
Screw the 90° bend of the installation set onto the
pressure outlet of your pump.
2. Screw the corresponding transition piece onto the
straight mounted bend or directly onto the pressure
connection of the pump.
Pump Transition piece
C(H)140 G 1¼ M
C(H)150 G 1¼ M
TCV408 G 1½ F
C(H)250 G 1¼ F
C(H)260 G 1¼ F
TP28 G 1½ F
3. Cut off the hose piece (D) on the appropriate length
(1-5). The correct number can be found in this list:
Pump Number
C(H)140 1
C(H)150 5
TCV408 1
C(H)250 3
C(H)260 4
TP28 -
B
C
D
4
3
2
5
1
C
G 1¼" AG
G 1½" IG
ENGLISH | 27