Adjusting Nylon Line; After Finishing Work; Transporting; Storing - Stihl FSA 130 Gebrauchsanleitung

12 After Finishing Work

► Move forward slowly in a controlled manner.
11.4 Saws with a circular saw blade
► Support the left side of the deflector against
the stem.
► Cut through the stem at full speed.
► A safety distance of at least 2 tree lengths to
the next work area.
11.5

Adjusting Nylon Line

11.5.1 Line Feed on AutoCut Mowing Head
► Tap the rotating mowing head on the ground.
About 30 mm of fresh nylon line is advanced.
The line limiting blade in the deflector trims the
mowing lines to the correct length.
2 1
Automatic feed does not operate if the mowing
lines are shorter than 25 mm.
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Depress the spool (1) on the mowing head
and hold it depressed.
► Pull out the mowing lines (2).
► If the mowing lines (2) cannot be pulled out to
the required length: Replace the spool (1) or
the mowing lines (2).
The spool is empty.
11.5.2 Line Feed on SuperCut Mowing Head
Mowing lines are advanced automatically. The
line limiting blade in the deflector trims the mow‐
ing lines to the correct length.
Automatic feed will not take place if the mowing
lines are shorter than 40 mm.
0458-726-9621-C
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Pull out the mowing lines.
► If the mowing lines cannot be pulled out to
required length: Replace nylon line.
The spool is empty.
12 After Finishing Work
12.1 When Work is Finished
► Switch off the brushcutter, move retaining
latch to position and pull the connecting
cable plug out of the socket.
► If the brushcutter is wet: Allow the brushcutter
to dry.
► Insert the plug in the socket.
► Clean the brushcutter.
► Clean the deflector.
► Clean the cutting attachment.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.

13 Transporting

13.1 Transporting the brushcutter
► Switch off the brushcutter, move retaining
latch to position and pull the connecting
cable plug out of the socket.
► Insert the plug in the socket.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.
Carrying the brushcutter
► Carry the brushcutter in one hand properly
balanced by the shaft, with the cutting attach‐
ment behind you.
Transporting the brushcutter in the car
► Secure the brushcutter to prevent turnover
and movement.

14 Storing

14.1 Storing the Brushcutter
► Switch off the brushcutter, move retaining
latch to position and pull the connecting
cable plug out of the socket.
► Insert the plug in the socket.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.
English
39