Inserting/Removing The Rechargeable Battery; Operating; Switching On - Parkside PKSA 20-Li B2 Originalbetriebsanleitung

little oil where smoke development
or discoloration of the rail occurs.
The chainsaw is equipped with an auto-
matic oiling system. As soon as the motor
is speeded up, the oil also flows faster to
the chain bar (8).
Switch off the device and remove
the battery before carrying out any
maintenance work.
Filling up with chain oil:
• Check the oil fill level and regularly top
up with oil (13).
• Use bio-oil; this product contains ad-
ditives that reduce wear and tear and
does not damage the pump system. bio-
oil is available from our Service-Center.
• If you have no bio-oil available, use
chain lubrication oil with low adhesive
additive content.
• Empty the oil tank before longer peri-
ods (6-8 weeks) of non-use.
1. Unscrew the oil fill cap (4) and
fill up with chain oil.
2. Wipe off any spilled oil and
close the cap again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.
Inserting/removing the
rechargeable battery
1. To insert the battery (16) into the de-
vice, push the battery along the guide
rails (23) into the device. You will hear
them click into place.
2. To remove the battery (16) from the de-
vice, press the release button (
on the battery and pull the battery out.

Operating

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled.
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.
Caution! Saw can oil up, see notes
on Operation startup.

Switching on

1. Place the battery (
device (see "Inserting/removing the
rechargeable battery").
2. Check before the start,
- whether sufficient chain oil is in the
tank and, if necessary, refill with
chain oil (see Chapter Operation
Start).
- the charge status of the battery.
3. Release the chain brake, where you
shift the brake arm (6) back against the
front grip (5).
4. Hold the chainsaw firmly with both
hands, with the right hand on the rear
grip (1) and the left hand on the front
handle (5). Thumb and finger must
close securely over the handles.
5. For switching on, activate the switch-on
block (3) with the right thumb and then
press the On/Off switch (2), the chain-
saw runs with highest speed. Release
the switch-on block (3) again
6. The power saw switches off when you
release the On/Off switch (2) again.
Switching for continuous running is not
possible.
GB IE
16a)
16) into the
45