Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Technical data
Type
Supply voltage
Maximum capacity
Settings
Thermostat
Isolatieklasse
Dimensions
Weight
General safety instructions
1.
Before using the machine, carefully read this entire instruction manual.
2.
Before using your new heater, check it, including cord and plug, for any visible damage. Do not use a
damaged heater, but send it back to your dealer for replacement.
3.
This heater is strictly intended for normal domestic use. Only use it as an additional heater in your home.
4.
This heater is, in principle, suitable for use in wet or damp spaces such as bathrooms, wash rooms etc.
(IP21). Keep it at least 1.5 m from water sources and water reservoirs (bath, sink, toilet) and ensure that it
can never fall into water and that no water penetrates the heater itself. If the heater does get wet make sure
you remove the plug from the socket! Do not use a heater that is wet inside but take it to be repaired. Never
immerse the cable or plug in water or any other fluid and never touch the heater with wet hands.
5.
The supply voltage and utility frequency, specified on the machine, need to match those of the socket that is
used. The electrical installation needs to be protected by a residual current device (max. 30 mAmp).
6.
Fully extend the cord before plugging in the heater. Make sure it does not come into contact with any part of
the heater and prevent it from heating up any other way. Do not run the cord underneath carpeting; do not
cover it with mats, carpet strips, or similar and make sure it is not placed in any passageways. Make sure the
cord cannot be stepped on and that no furniture is placed on top of it. Do not lead the cord around sharp
corners and do not roll it up too tightly after use!
7.
If possible, do not use an extension cord, as this poses the risk of overheating and fire. If the use of an
extension cord is unavoidable, then make sure it is an undamaged, approved extension cord with a minimum
diameter of 3 x 1.5 mm² and a minimum permissible power of 2000 Watt/10Amp. To prevent overheating,
always fully extend the cord!
8.
To prevent the circuit being overloaded and fuses being blown, make sure no other appliances are connected
to the same socket or wired to the same electrical circuit as the heater.
9.
Do not use the heater outdoors and do not use it in spaces smaller than 6 m².
10. A heater contains hot and/or glowing and sparking components. Do not, therefore, use it in areas where
fuels, paint, flammable liquids and/or gasses etc. are stored.
11. Do not place the heater near, under, or directly opposite a socket and do not place near an open fire or other
heat source.
12. Do not use the heater near or directly opposite furniture, animals, curtains, paper, clothes, bedding or other
inflammable objects. Keep them at least 1 metre away from the heater!
13. Never cover a heater! The heater's air inlets and outlets should never be obstructed in any way, so as to
prevent the possibility of fire. Never use the heater to dry clothes and do not place anything on top of the
heater.
14. Make sure that the air around the heater can circulate freely. Do not place the heater too close to walls or
large objects and do not place it under shelves, cupboards, and similar.
15. Prevent foreign objects from entering the heater via the venting or exhaust openings as this may lead to
electric shock, fire or damage.
16. Never leave the heater unattended when switched on. Always switch if off before removing the plug from the
socket. Always unplug the heater when not in use! Pull on the plug to remove from the socket, never pull on
the cord!
17. Always switch the heater off, unplug it and leave to cool down before:
-
cleaning the heater
-
carrying out maintenance on the heater
-
touching or moving the heater. Use the handle for this!
18. This machine gets hot when it is in use. To prevent burns, do not let bare skin come into contact with hot
surfaces.
19. Do not use a timer or a similar product to automatically switch on the heater. Always perform safety checks
before using the heater!
English
BK2003
Volt/Hz
220-240 / 50
Watt
2000
0 – Fan – 1000W – 2000W
Watt
+
IP21
9,5(22,5)x60,5x39
cm
kg
1,25
11
Werbung
Inhaltsverzeichnis
