Installing Updates For The Home Connect Software - Siemens KF86F-Serie Gebrauchsanleitung

Home Connect
en
Connecting the refrigerator to the Home Connect app
The appliance automatically connects to the app with
set-up for the first time after a connection to the home
network (WLAN) has been established.
If the appliance does not automatically connect to the
app, connect the appliance manually:
Press settings button.
1.
The |connect button lights up.The cool-fresh
compartment temperature display shows Cn.
Keep pressing N/M button cool-fresh compartment
2.
until the cool-fresh compartment temperature display
shows PA and the freezer compartment temperature
display shows OF.
Press N button freezer compartment to connect the
3.
appliance to the app.
The freezer compartment temperature display shows
an animation.
As soon as the refrigerator and the app are
connected, the freezer compartment temperature
display shows On.
Open the app and wait until the refrigerator is
4.
displayed.
Use Add to confirm the connection between the app
and the refrigerator.
If the refrigerator is not automatically displayed, click
on Add appliance in the app and follow the
instructions. As soon as your refrigerator is
displayed, add it with +.
Follow the instructions in the app until the process is
5.
complete.
The cool-fresh compartment temperature display
shows PA and the freezer compartment temperature
display shows On.
The refrigerator has been connected to the app.
If the connection fails, check whether the mobile
device is connected to the home network (WLAN).
Then try to establish the connection again.
If Er appears in the freezer
compartment temperature display, reset the
Home Connect settings.
With reset, all Home Connect settings are
Note:
reset.
Checking signal strength
You should check the signal strength if no connection
can be established.
Press settings button.
1.
The |connect button lights up.The cool-fresh
compartment temperature display shows Cn.
Keep pressing N/M button cool-fresh compartment
2.
until the cool-fresh
compartment temperature´display shows SI.A value
between 0 (no signal) and 3 (full signal) appears in
the freezer compartment temperature display.
The signal strength should be at least 2. If the signal
strength is too weak, the connection may be
interrupted.
– Place the router and refrigerator closer together.
– Check that screening walls do not interfere with
the connection.
– Or install a repeater to make the signal stronger.
50
Resetting Home Connect settings
If there is a problem when trying to establish a
connection or if you would like to register the appliance
in a different home network (WLAN), the Home
Connect settings can be reset:
Press settings button.
1.
The |connect button lights up.The cool-fresh
compartment temperature display shows Cn.
Keep pressing N/M button cool-fresh compartment
2.
until the cool-fresh compartment temperature display
shows rE and the freezer compartment temperature
display shows OF.
Press N button freezer compartment.
3.
The freezer compartment temperature display shows
an animation for 15 seconds.
The freezer compartment temperature display then
shows OF.
The Home Connect settings have been reset.
Installing updates for the Home
Connect software
The refrigerator checks at regular intervals whether
updates are available for the Home Connect software.
If an update is available, the temperature display
shows UP:
Confirm update in Home Connect app.
■
Do not switch the refrigerator off during updates.
The freezer compartment temperature display shows
an animation. The update is installed.
All buttons are locked during installation.
Note:
If installation was successfully completed, the freezer
■
compartment temperature display will show On.
If installation was not successfully completed, the
■
freezer compartment temperature display will
show Er.
Start the update again at a later time.
If installation cannot be completed even after
multiple attempts, notify Customer Service.
Press any button to reset the display to the set
temperature.