Siemens KF86F-Serie Gebrauchsanleitung Seite 39

Aligning the drawers
You can align the drawer vertically:
Open the drawer as far as it will go and remove the
1.
container.
Remove the middle screw on both sides.
2.
If you want to reset to the drawer to the factory
Note:
settings, retain the screws.
Installation and connection
Loosen the upper screw on both sides.
3.
Do not remove the screws.
Note:
Lift the drawer and remove the lower screw on both
4.
sides.
Move the drawer upwards or downwards into the
5.
required position and screw the lower screw into one
of the available holes.
The drawer can be adjusted by 1/16"
Note:
(1,6 mm) up and down.
Retighten all screws.
6.
To check the position, close the drawer and correct
7.
if necessary.
en
39