Nolan N20 Traffic Sicherheit Und Gebrauchsanleitung Seite 8

INSTRUCTIONS FOR USE
• VISOR
1 Visor disassembly
(only for versions with visor)
1.1 Close the visor and remove the side plate from the helmet by pulling the rear end
outwards (Fig. 1).
1.2 Push the visor mechanism slider forwards as shown by the arrow (Fig. 2).
1.3 Lift the rear area of the visor from the shell until it is completely released from the
mechanism; slightly push it towards the front of the helmet (Fig. 3).
1.4 Repeat all the operations on the other side as well.
2 Visor assembly
2.1 Place the visor on the shell taking care to align the teeth seat with the front part
of the mechanism; hook the visor under the mechanism by pressing it against
the helmet in the teeth area and simultaneously pushing it towards the rear part
of the helmet so as to completely hook it to the mechanism (Fig. 4).
2.2 Move the slider backwards until you hear the fastening click (Fig. 5).
2.3 Assemble the side plate taking care to centre the internal hooks in the relative
seats on the mechanism and pressing until you hear the fastening click (Fig. 6).
2.4 Repeat the operations on the other side as well.
WARNING!!!
- Make sure that the mechanism operates properly by pulling up and down the visor.
- The helmet should always be used with all of its components correctly assem-
bled. Should any of the components be malfunctioning or damaged, please refer
to a Nolan authorized dealer.
Warning: Check the size before purchasing a new visor. The visor is available in
two sizes, according to the size of the purchased helmet:
Helmet size ≤ Size M Visor " SMALL"
Helmet size ≥ Size L Visor " LARGE"
• REMOVABLE INNER COMFORT PADDING
(only for versions with removable inner padding)
3 How to remove the inner comfort padding
3.1 Open the chin strap (see specific instructions).
3.2 Remove the inner comfort padding from the helmet (Fig. 7).
4 How to fit the inner comfort padding
4.1 Correctly insert the comfort padding, placing it inside the helmet, making sure it
adheres to the hook-and-loop strips (Fig. 8).
8