Installation On A Wall; Carbon Filter - Pkm UBH 4060-2H Bedienungsanleitung

2.4 Installation on a wall

1. If the cupboard is not suitable for installation, you can carry out a wall installation.
Screw 2 supplied screws into the wall relevant to the position of the 2 slots for
the screw heads on the back of the appliance. Do not tighten the screws
completely as you have to hang the appliance on the screw heads.
115
A
2. Hang the appliance on the screw heads. Insert the screw heads into the round
slots; then move the appliance so that the screw heads are in the narrow section
of the suspension. Tighten the 2 screws to ensure safe and proper positioning.
3. Fix screws through the small safety holes to protect the appliance from
unintended moving.

2.5 Carbon filter

WARNING! Before you install any carbon filters: switch the appliance
off and disconnect it from the mains.
WARNING! Install the carbon filters safely and properly; otherwise the
carbon filters can loosen and cause hazardous situations.
NOTICE! The suction capacity is decreased by installed carbon filters.
1. Remove the aluminium grease filter.
2. Install the carbon filter on the bottom side of the motor (bayonet catch).
3. Reinstall the aluminium grease filter.
4. Use carbon filters for extraction mode only.
600
Fig. similar: fig serves as an example only.
S
AFETY HOLE
37