Setting A Communication Speed; Self-Diagnosis Function - Sony FWD-40LX1 Bedienungsanleitung

Setting a communication speed

1
In the INITIAL SETUP/INFORMATION menu,
select "Speed Setup" with M/m and press ENTER.
INITIAL SETUP/INFORMATION
Speed Setup
Speed: Auto Detect
Execute
Select Set
ENTER
2
Press ENTER and select a communication speed
with M/m, then press ENTER.
Select "Auto Detect" when you want to set an
appropriate communication speed for your
network configuration automatically.
INITIAL SETUP/INFORMATION
Speed Setup
Speed: Auto Detect Auto Detect
Execute 10Mbps/Half Dup
10Mbps/Full Dup
100Mbps/Half Dup
100Mbps/Full Dup
Select Set
ENTER
3
Select "Execute" and press ENTER.
Select "OK" and press ENTER.
A communication speed has been set.
Setting an IP address and communication speed / Self-diagnosis Function
Exit
MENU
Exit
MENU

Self-diagnosis Function

The unit has a self-diagnosis function.
This function shows the display's condition based on
the pattern shown by the flashing of the POWER/
STANDBY indicator. The flashing pattern informs
you of the display's current condition.
If the POWER/STANDBY indicator flashes, check
the number of flashes and contact your authorized
Sony dealer.
1
Check the flashing pattern of the POWER/
STANDBY indicator.
The indicator flashes (with an image showing on
the display) or flashes at intervals of three seconds
(with no image showing on the display).
Count the number of flashes if the indicator
flashes at intervals of three seconds. For example,
the indicator flashes twice, followed by a three
second pause, two more flashes and this pattern
repeats. In this case, the count for the number of
flashes is two.
2
Unplug the unit.
Inform your authorized Sony dealer of the number
of flashes.
41
(GB)