Use Of Dishwasher Salt - Electrolux ESF 45030 Benutzerinformation

26 electrolux
• mmol/l (millimol per litre - international unit
for the hardness of water).
• Clarke.
Water hardness
°dH °TH
51 - 70 91 - 125
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at po-
sition 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.

Use of dishwasher salt

Caution! Only use dishwashers salt.
Types of salt that are not applicable for
dishwashers cause damage to the water
softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
mmol/l Clarke
9,1 - 12,5 64 - 88
7,6 - 9,0 53 - 63
6,5 - 7,5 46 - 52
5,1 - 6,4 36 - 45
4,0 - 5,0 28 - 35
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
Adjust the water softener to the water hard-
ness in your area. If necessary, contact your
local water authority.
Water hardness setting
manually
2
2
2
2
2
2
1
1
1
1)
1
Electronic adjustment
The water softener is set at the factory
at level 5.
The appliance must be switched off.
1. Press and hold the start/cancel button.
Turn the programme knob counterclock-
wise until the programme marker agrees
with the first washing programme on the
control panel.
2. Release the start/cancel button when the
digital display shows the current setting.
Examples:
– level 5 =
– level 10 =
3. Press the start/cancel button to change
the water softener level. Every time you
press the button, the level increases.
4. Turn the programme knob to the off po-
sition to save the operation.
salt before you start a washing
programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the
salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
electronically
10
9
8
7
6
5
4
3
2
1)
1