Care & Cleaning; Troubleshooting - Sage the Citrus Press Pro 800CP Kurzanleitung

Care & Cleaning
• Always ensure that the juicer is turned OFF
at the ON/OFF switch and the plug is removed
from the power outlet before cleaning,
disassembling, assembling and storing the
appliance.
• Follow these instructions to clean all surfaces
or parts that come into contact with food during
juicing.
• For easy cleaning immediately after each use
rinse removable parts under warm water to
remove wet pulp. Allow parts to air dry
before reassembling.
• For thorough cleaning after disassembling the
appliance, all removable parts should be washed
in hot soapy water or on the top shelf of the
dishwasher. The base and juice press arm should
be wiped with a soft, damp cloth. All parts should
be dried thoroughly before reassembling.
• Store the cleaned and reassembled juicer in an
upright position in a cool, dry place. Do not place
any items on top of the juicer while stored.
• Rinse or wash all removable parts immediately
after use. Dried citrus pulp is difficult to remove
and may stain. If any staining does occur,
wipe the discoloured part(s) with undiluted
dishwashing liquid, rinse and dry thoroughly.
• Do not soak the filter or other removable parts in
bleach. Never immerse the motor base in water
or any other liquid. Do not use harsh abrasives.
All manuals and user guides at all-guides.com

Troubleshooting

POSSIBLE EASY SOLUTION
PROBLEM
Will not
• Switch not in the ON position.
work
• Juice press arm not lowered.
• Juicing cone or fruit dome not
assembled properly.
• Filter not assembled properly.
• Motor overload protection
may have operated (see
below).
Motor
• The juicer is fitted with an
Overload overload protector to prevent
Protection
damage to the Motor.
If the Motor suddenly stops
working after heavy or long
periods of use, turn OFF
at the ON/OFF button, unplug
from the wall and allow the
unit to cool for 15 minutes.
Once the unit is cooled you
will be able to use the juicer
again as normal.
NOTE: The unit MUST be
unplugged from the supply
to allow the protector to reset.
• Despite this overload
protector we suggest juicing
in smaller batches in order
to protect the Motor.
EN
7