Fein WPO10-25E Originalbetriebsanleitung Seite 17

OBJ_BUCH-0000000053-001.book Page 17 Thursday, January 19, 2012 2:41 PM
en Original Instructions for Angle Polisher.
Symbols, abbreviations and terms used.
Symbol, character Explanation
General prohibition sign. This action is prohibited.
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this work step, pull the mains plug out of the socket. Otherwise there will
be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
A surface that can be touched may be very hot and thus hazardous.
Gripping surface
Additional information.
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Product with double or reinforced insulation
Low speed
High speed
Character Unit of measurement,
international
n /min
P W
1
P W
2
U
V
f
Hz
M... mm
Ø mm
mm
mm
kg
Unit of measurement, Explanation
national
rpm Rated speed
W Power input
W Output
V Rated voltage
Hz Frequency
mm Size of metric thread
mm Diameter of a round part
mm Ø =Max. application tool diameter
D
mm M=Thread for clamping flange
l=Length of mounting thread
kg Weight according to EPTA-Procedure
01/2003
en
17