Citizen CT-S281 Benutzerhandbuch Seite 34

When using "label paper" with CT-S281XL/OL, refer to the following. Use the
following paper or the equivalent paper.
Paper type
Recommended thermal label paper
b) Label paper
C
L
Paper feeding
E
F
Printable area
G
CAUTION!
● Do not use full sheet label paper.
● Use label paper with peel force of 200 mN/50mm between label and liner. Using label
paper with weak peel force may result in paper jam.
● In some case, adhesive may be present between label papers or at the edge of label.
Fixing adhesive on the paper path such as print head, etc. may result in paper jam. At
the occurrence of paper jam, check for fixed adhesive. Remove the fixed adhesive
using close moistened with ethanol.
● When label length is less than 30 mm and the cutter is set to be disabled, feeding the
unlabelled area to the manual cut position and then to the first print position by using
the GS FF command may cause label paper to feed one or two sheets without printing.
● Observe the life and storage condition of label paper when using label paper.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
HD75 from Nippon Paper
150HBW from Ricoh
A
B
D
Full cut
position
direction
V10 CONSUMIBLES S.L.
M
H I
Mark
A Liner width
B Label width
C Left edge of label
D Print width
J K
E Top margin
F Print length
G Bottom margin
H Cut position between labels
I Gap between labels
J Label length
K Label pitch
L Left margin
M Right margin
— 31 —
Product name
Item Dimensions
0
58
-1
_
54 + 0.5
2 + 0.5 _
48
_
2 + 1
21 to 156 + 1
2 + 1 _
2 or more
5 + 1
_
25 to 160
I+J
3 + 1 _
3 + 1 _
Unit: mm
_