If no signal is received, proceed as follows:
Press the SENSOR button for approx. 2 seconds to initiate the reception of the measured values
again.
28 Rainfall
The amount of precipitation is displayed on the base station in millimeters or inches that has accumu-
lated over a period of time, based on the current precipitation rate.
Select display mode
Press the RAIN key repeatedly until the desired time period is shown on the display:
HOURLY
DAILY
WEEKLY
MONTHLY
TOTAL
RATE
Select measurement unit (millimeters or inches)
1. Press the RAIN key for about 3 seconds to enter unit setting.
2. Press the UP or DOWN key to toggle between mm (millimeters) and in (inches).
3. Finally, press the RAIN key to save the settings and exit settings mode.
NOTICE! The readings are automatically updated every 6 minutes.
29 Light intensity, UV index and sunburn time
This section shows the light intensity level, UV index and sunburn time. Press the SUN button to
change the mode.
52 / 96
Current precipitation of the last hour
Total precipitation of the current day, measured from midnight
Total precipitation of the current week
Total precipitation of the current month
The total rainfall since the last reset
Current precipitation of the last 10 minutes