Technical Data - HSM SECURIO P40ic Betriebsanleitung

9

Technical data

Cutting type
Cut size (mm)
Security level DIN 66399
Cutting capacity* (sheets), A4
Weight
Cutting speed
Intake width
Power supply
Power consumption with max. number of
sheets
Energy consumption in standby mode
Operating mode
Dimensions W x D x H (mm)
Ambient conditions in operation:
Temperature
Relative humidity
Height above sea-level (MSL)
Volume of the shredded paper container
Sound pressure level emissions
(Idle running/ load)
A-weighted sound power level (LWAd in
idle mode)
Cutting size of the separate CD cutting
unit (optional)
Security level of the CD cutting unit
* The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one specifi ed could result in less sheet capacity and increased noise during oper-
ation. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.
** Identifi ed by the letter after the 7-digit order number on the name plate on the back of the machine.
e.g. 1873111C >> cutting size 4 x 7 mm
This document shredder meets the applicable harmonisation legislation of the European Union:
• Low Voltage directive 2006/95/EU
• EMC directive 2004/108/EU
• RoHS directive 2011/65/EU
The EU declaration of conformity can be requested from the manufacturer.
18
Strip cut
5.8 3.9
P-2 / O-2 P-2 / O-2
T-2 / E-2 T-2 / E-2
70 g/m 58 - 60 45 - 47
2
80 g/m 51 - 53 40 - 42
2
67 kg
100 mm/s
Order number +C, E **
4 x 7 mm
O-4 / T-5 / E-4
SECURIO P 40
english
Cross cut
4.5 x 30 1.9 x 15
P-4 / O-3 P-5 / O-4
T-4 / E-3 T-5 / E-4
F-1 F-2
35 - 37 22 - 24
31 - 33 18 - 20
72 kg
110 mm/s
330 mm
230 V, 50 Hz
2.100 W
< 2 Wh
Continuous operation
580 x 550 x 936
-10 °C to +25 °C
max. 90 %, without condensation
max. 2,000 m
145 l
60 - 62 dB(A) / 65 - 69 dB(A)
69.0 dB
Order number +M, N **
0.78 x 11 1 x 5
P-6 / F-3 P-7 / F-3
13 - 14 10
11 - 12 8
2 x 2 mm
O-6 / T-6 / E-5
09/2015