Residual Risk - BATTIPAV Expert 400 Bedienungsanleitung

GB
26 27
Put the motor head in position as indicated in the picture in order to take advantage of maximum cutting capacity.
• By means of the cutting square, arrange the piece to be cut on the working table at the desired measurement.
28
• Start the machine and carry out the first cut.
29
• Turn over the piece 180°, and repeat the cut.
40
WITH THE SIDE STOP IT IS POSSIBLE TO LOCK THE TABLE IN ADVANCED POSITION.
LASER MARKER
CLASS IIIA LASER INSTRUMENT
By means of the laser marker accessory, the cutting operations can be accelerated.
As a matter of fact, the special laser system is able to indicate the tool cutting line on the working table.
THE LASER MARKER STARTS WORKING ONCE THE MACHINE IS CONNECTED TO THE POWER SUPPLY.
DIRECT EXPOSURE TO SUNLIGHT MAY REDUCE THE LASER MARKER EFFECTIVENESS.
IT IS THEREFORE ADVISABLE TO USE THE MACHINE INDOORS.
31
CUTTING WITH LASER MARKER
• connect the machine to the power supply;
• position the piece to be cut making sure that the line indicated by the laser marker matches the reference on the material to be cut;
• perform the cutting operation as indicated in the paragraph: "CUTTING ON THE TABLE".
DO NOT MODIFY THE MARKER POSITION BY TURNING THE BEAM TOWARDS THE OPERATOR'S EYES. DO NOT
GAZE AT THE BEAM WITH THE NAKED EYE OR LOOK DIRECTLY WITH OPTICAL INSTRUMENTS.
MARKER ADJUSTMENT
In case the marker is not aligned with the cutting line, its correct alignment can be adjusted.
In order to correctly position the marker, proceed as follows:
30
• loosen the three bulb locking screws so that it can be moved;
31
• position a reference properly on the tool cutting line;
30
• insert the 5 mm Allen wrench provided in the hexagonal slot located on the bulb;
30
• using the Allen wrench, turn the bulb until aligning the mark with the tool cutting line
DURING THE ADJUSTMENT OPERATIONS, MAKE SURE THAT THE LINE PRODUCED BY THE MARKER DOES NOT
REACH THE OPERATOR'S EYES.
ALWAYS KEEP A SAFETY DISTANCE BETWEEN THE OPERATOR'S EYES AND THE END OF THE LINE. THE MANUFACTURER
32
DECLINES ANY LIABILITY FOR THE USE OF THE LASER MARKER IN APPLICATIONS OTHER THAN THE INDICATED APPLICATION.

RESIDUAL RISK

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the safety and health
of operators. In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current:
The machine has an internal electric system. CONNECT THE MACHINE TO A SYSTEM WITH DIFFERENTIAL
PROTECTION AND EFFECTIVE EARTH WIRE.
Danger of prolonged exposure to noise:
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
Danger of accidental contact with the moving tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE GLOVES
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 21) DURING THE MACHINE OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the machine stop.
46
Battipav srl