Factory Setting; Technical Specifications - urmet 1067 Bedienungsanleitung

FACTORY SETTING

The Ethernet interface can be identified by MAC Address (ID Address) printed on the label:
The default parameters are the following:
(*) To change programming, refer to the documentation on the Software installation CD.
"FastPro" from version 2.0 ("Ethernet" page) using a PC and the Ethernet Cross cable supplied.

TECHNICAL SPECIFICATIONS

Rated supply voltage (from control panel to flat cable) ..................................................................... 13,8 V─
Min/max operating voltage ......................................................................................................... 9V─ ÷ 15V─
Rated input current at 13,8 V:
Standby (Eth. network cable not connected) ................................................................................ 60 mA
Ethernet network on 10Mbps (LED 1 Amber) ............................................................................. 110 mA
Ethernet. network on 100Mbps (LED 1 Green) ............................................................................ 90 mA
Dimensions (W x H x D) ..................................................................................................... 86 x 54 x 18 mm
6
MAC
Parameter Default state
Password
DHCP
IP 192.168.1.30
SMN 255.255.255.0
Gateway
Port
115200, 8, N, 1
Serial
Encryption
00-20-4A-XX-XX-XX
urmet1234
No
192.168.1.1
8030
No flow ctrl
Disabled
Program. (*)
YES
NO
YES
YES
YES
YES
NO
YES
DS1067-018B