Cleaning, Maintenance And Storage; General Cleaning And Maintenance Work; Changing The Blade; Storage - Parkside PRM 1800 A2 Originalbetriebsanleitung

GB
IE
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.
Cleaning, Maintenance
and Storage
Have work that is not de-
scribed in these instructions
carried out by a customer
service centre that we have
authorised. Use only original
parts.
Wear gloves when handling the
blade.
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until the
blade stops. There is a risk of injury.
General Cleaning and
Maintenance Work
Do not hose down the lawn-
mower with water.
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmower
for obvious defects such as loose, worn
or damaged parts. Check that all nuts,
bolts and screws are sitting firmly.
32
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.
I

Changing the Blade

If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade is
damaged or showing signs of imbalance,
it must be replaced (see chapter on "Spare
Parts").
1. Switch off the equipment, disconnect
the plug and wait until the blade stops.
2. Turn the equipment over.
3. Use sturdy gloves and hold the blade
firmly (19). Turn the blade screw (18)
anticlockwise off of the motor spindle
(20) using a screwdriver (AF 13 mm).
4. Install the new blade in the reverse or-
der. Ensure that the blade is positioned
correctly and the screw tightened
firmly.

Storage

• Keep the equipment dry and out of
reach of children. Loosen the wing nuts
and fold down the handle bar so the
equipment takes up less space. See the
diagramm .
H
not be jammed when you do this.
• Allow the motor to cool before storing
the equipment in a confined space.
• Do not cover the equipment with nylon
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
The machine cable must