Hauck Varioguard Gebrauchsanweisung Seite 33

- Ensure the seat liner is suitable for the weight and age of your
child!
- Check the harness is secure with the buckle and shoulder
strap connectors latched together and harness tension is
correct (27, 28)!
- Check the car seat is facing rearwards in the vehicle (9) and in
the fully reclined position!
IMPORTANT! Misusing your child car seat will reduce the
protection and safety you offer your child.
REARWARD FACING FOR GROUP 1 (ISOFIX only)
(9kg to 18kg / approx. 9 months to 4 years)
Firstly you must install the car seat base into your vehicle using
the ISOFIX-points. See section 'Installing the base - using the
ISOFIX points'.
You must also ensure that the harness and headrest is set cor
rectly for your child, to do this see sections 'Headrest and Safety
Harness Adjustment' and 'Harness Tension and Adjustment'.
The car seat includes a seat liner and head hugger (C1) for the
small baby.
The liner has a cushion inserted in a pocket on the back of the
liner which is suitable for children up to approx 9Kg or 12 months.
remove the cushion and use only the liner while the car seat is
rearward facing.
INSTALLING THE CAR SEAT ONTO THE BASE FULLY
RECLINED
Firstly make sure that the seat is in its fully reclined position, then
place the car seat onto the base facing towards the rear of the
vehicle and press the car seat down until you hear a "click" (9).
Check the seat is secure by lifting the seat upwards.
To remove the car seat from the base, at the same time press the
car seat release button (Y) while lifting the car seat up from the
base (10, 11).
INSTALLING YOUR CHILD IN THE CAR SEAT
Firstly open the buckle by pressing the red button in the centre of
GB
33