Zehnder ComfoAir 550 Installationsanleitung Seite 82

Submenu Description
P59 Confi rming the presence of an enthalpy exchanger.
• 0; Enthalpy exchanger not fi tted
• 1; Enthalpy exchanger with RH sensor.
• 2; Enthalpy exchanger without RH sensor.
Menu P6  Setting additional programmes
Submenu Description
P60 Confi rming the presence of a geothermal heat exchanger.
• 0; Geothermal heat exchanger not fi tted
• 1; Geothermal heat exchanger fi tted
• 3; Geothermal heat exchanger unregulated.
Menu P7  Reading malfunctions (and system information)
Submenu Description
P70 Current software version.
P71 Most recent malfunction.
P72 Malfunction before the most recent one
P73 Malfunction before the most recent two
P74 Resseting malfunction(s)
• Set value tot '1' and press "OK" on the
display.
P75 General reset.
• Press "OK" on the display for at least 5
seconds to carry out a general reset.
All original software settings are re-
stored following a general reset.
Note:
After a general reset, the ComfoAir will ask you to reset the "nL / HL" (see P56) and "Li / Re"
(see P57) settings.
Following a general reset, all settings and programmes need to be checked and set to the right
value.
P76 Self-testing the ComfoAir
• The LED's on the display will start blinking.
• The ComfoAir will run at maximum Rotation Per Minute (RPM).
• The bypass valve will open and close.
• The preheater valve will open and close after the bypass has closed (If a preheater element is fi t-
ted).
P77 Resetting fi lter dirty counter
Note:
This resets the counter that triggers a dirty fi lter alert on the ComfoAir. This allows the fi lter to be cleaned
or replaced before the dirty fi lter alert appears.
Only a enthalpy exchanger without RH sensor can be fi tted.
Only a unregulated geothermal heat exchanger can be fi tted.
Additional programme values
Minimum
0 (= No)
Additional programme values
Minimum
0 (= No)
(Malfunction) information values
Minimum Maximum
Version number of the software (without "v")
Code in accordance with alarm and malfunction alert
Code in accordance with alarm and malfunction alert
Code in accordance with alarm and malfunction alert
0 1
(= activate)
0 1
(= activate)
0 1
(= activate)
0 1
(= activate)
Maximum General
Reset
2 (= Yes) 0
Maximum General
Reset
3 (= Yes) 0
General
Reset
0
0
0
0
13 - EN