Maintenance / Care; Troubleshooting Tips - Würth WPS 12-900 Originalbetriebsanleitung

Maintenance / care

Disconnect the device from the
power supply, prior to performing
maintenance or repair work.
Charge the battery immediately after purchase,
after each use and also every 30 days for at least
12 hours.
Protect the device against humidity and moisture.
Fault
Vehicles can not be remote
started with the device.
The device battery is not
being charged.
Fault for 12-900
The device shows a charge
is still lit up on the charger
(charging).
is lit up.

Troubleshooting Tips

Possible cause
The terminals do not indi-
with the battery.
The device is not charged.
Die vehicle battery is
defective.
The fuse is defective.
The battery is defective.
Possible cause
The device battery is not
completely charged.
connections between the
charger and the Power
Start.
Defective battery (does not
charge up any-more).
The charger is in abort
mode.
Clean the device only by using a clean, dry cloth.
Store the device in an upright position in a cov-
ered, cool and dry place.
Check the unit before each use and every
30 days for damage.
Remedy
Check whether, the terminals are correctly connect-
ed with the vehicle battery and the vehicle chassis.
and corrosion free).
Move the clamp back and forth to provide better
contact.
Check the battery charging state by pressing the
button at the front of the device
(see section
Have the battery checked.
(See section
Replace the fuse.
Have the battery checked.
Remedy
charger lights up.
Check the connection Check that the connection
points are clean.
Have the battery checked.
See section
).
).
.