Würth WPS 12-900 Originalbetriebsanleitung Seite 17

Flashes The charging process can not
red be completed normally and
will be aborted.
To reset the device after
an aborted charging, dis-
connect the charger from
the power outlet for a few
seconds.
Is lit The device is being charged.
yellow
Is lit The device is fully charged
green and the charger is in the trickle
mode, this means, the full
charge of the battery is main-
tained without damaging it.
Is lit
green The charger is connected to
a socket.
Lit
yellow/ The device is being charged.
orange
Is lit
green The device is fully charged
and the charger is in trickle
mode; this means that the full
charge of the battery is main-
tained without damaging it.
Is lit red
The charger has detected a
problem with the device batter-
ies. They could be damaged
or sulphated. If this is the case,
contact your dealer.
Is lit red
The charging circuit has
reversed connections; contact
your dealer.
Plug the charger plug in the connector
side of the device.
Check if the voltage applied to the AC outlet volt-
age matches the input voltage of the charger.
Plug the charger plug in a wall socket.
charging. Once the charging process
A complete charging process can last
up to 12 hours.
After charging, disconnect the charger from the
alternating current source.
Disconnect all connections between the charger
and the Power Start.
Checking the charging state
and that the device is not connected to the vehicle
battery.
Press the charging state button
The charging state of the device is indicated on
the display in percent.
indicates less than 80%.
Upon switching on the operating switch
, the voltage of the internal battery is
shown in volt.
at the
is set to "0"
.
display