Safety Precautions - Stihl Smart Connector Gebrauchsanleitung

IMPORTANT! READ BEFORE USING
AND KEEP IN A SAFE PLACE FOR
REFERENCE.
Read and observe the following
information and safety instruc‐
tions. Improper use can result in
serious injuries.
Read and follow all the safety
instructions in the Instruction
Manual for the STIHL product
or the third party product to
which the Smart Connector is
attached.
Further information about the Smart
Connector, STIHL connected, compati‐
ble products and FAQs are available at
https://connect.stihl.com/
STIHL authorized dealer.
®
The Bluetooth word mark and logos
are registered trademarks owned by
Bluetooth SIG, Inc. These word mark/
logos are used by STIHL under license.
The Smart Connector is equipped with a
®
Bluetooth radio interface. Local operat‐
ing restrictions (in aircraft or hospitals,
for example) must be observed.

Safety Precautions

Intended Use
The STIHL Smart Connector, in combi‐
nation with the STIHL App, enables the
personalization and transmission of
product running time data on the basis
®
of Bluetooth technology. The STIHL
Smart Connector can be used in the
rain.
WARNING
■ Using the Smart Connector other
than for its intended use can result in
serious injuries and damage to prop‐
erty.
► Always use the Smart Connector as
described in this Instruction Manual,
0457-399-0007-B. VA1.E21.
■ Batteries not approved by STIHL for
UseUse
or from a
■ If not in safe condition, components
the app and under
connect.stihl.com/
► Do not use the Smart Connector as
a toy. If using the Smart Connector
near children: Supervise the chil‐
dren.
the Smart Connector can cause fires
and explosions. Persons may be seri‐
ously or fatally injured and property
may be damaged.
► Use an IEC-CR2032 lithium button
cell approved for use in a tempera‐
ture range from - 30 °C to 60 °C.
WARNING
may no longer operate correctly and
safety devices may be disabled. This
may result in serous or fatal injury to
people.
► Use the Smart Connector with the
cover closed.
► Make sure that the sealing ring is in
the guide between the housing and
the cover.
► Close the cover so that the arrow
symbol points toward the dot sym‐
bol on the housing.
► Do not mount the Smart Connector
to handles, switches, controls,
safety devices, cooling air ducts,
moving parts or safety labels.
► Do not mount the Smart Connector
in areas exposed to heat or sparks.
► If using screws or rivets to fit the
Smart Connector: take care not to
damage electrical parts, cables, fuel
lines or other components.
► If using screws to fit the Smart Con‐
nector: use a suitable drill with a
https://
.
7