Parkside PPS 40 B2 Originalbetriebsanleitung Seite 11

come into contact with
flammable material.
Protect yourself and others
„
from flying sparks and hot
metal.
Please be careful because
„
sparks and hot materials can
easily fall through small gaps
and openings while cutting
and land on adjacent areas.
Please be aware that cut-
„
ting on a ceiling, floor or a
partition can cause a fire on
the opposite side that is not
visible.
Connect the power cable using
„
the shortest route with a socket
situated close to the workplace
to prevent the power cable
from being spread across the
whole room and located on a
surface which could cause an
electric shock, sparks or fire
outbreak.
Do not use the plasma cutter
„
to defrost frozen tubes.
Risk of electric shock:
WARNING!
f Electric shock from the cutting
electrode can be fatal.
Do not use the plasma cutter
„
when it is raining or snowing.
Wear dry insulating gloves.
„
Do not touch the electrodes
„
with bare hands.
Do not wear wet or damaged
„
gloves.
Protect yourself from electric
„
shock with insulation against
the workpiece.
Do not open the device
„
housing.
Additional protection against a
„
shock from the mains power in
the event a fault can be pro-
vided by using a fault-circuit
interrupter, which is operated
with a leakage current of no
more than 30 mA and covers
all mains-powered devices in
close proximity. The fault-circuit
interrupter must be suitable for
all types of current.
There must be means of rapid
„
electrical isolation of the
cutting power source or the
cutting circuit (e.g. emergency
stop device) which are easily
accessible.
Danger from smoke emis-
sion when plasma cutting:
Inhalation of fumes which
„
result from plasma cutting can
endanger health.
Do not keep your head in the
„
fumes.
Use the device in open areas.
„
Safety instructions
GB 11