Installing Batteries; Standby Mode - Thrustmaster T-Wireless 3-in-1 Rumble Force Benutzerhandbuch

INSTALLING BATTERIES

Insert 3 1.5V type LR03 / AAA batteries in the battery compartment located at the back of the gamepad (14).
OVERVIEW

POWER switch (13):
- OFF position = the gamepad is off (and doesn't use up batteries).
- ON position = the gamepad is on.

MOTORS switch (13):
- OFF position = vibration mode is disabled (uses less battery power).
- ON position = vibration mode is enabled (uses more battery power).

CONNECT buttons (8 and 12)
The connection between the gamepad and the receiver is established automatically.
These 2 buttons allow you to establish a connection in case of failure or when using more than one T-
Wireless gamepad at the same time.
- Both LEDs are on = signal between the gamepad and the receiver.
- Both LEDs flash quickly = no signal between the gamepad and the receiver.
- Both LEDs are off = the gamepad is in standby mode or switched off.
- Both LEDs flash slowly = change batteries.
 STANDBY MODE:
- The gamepad switches off automatically after 5 minutes of inactivity.
- To reactivate it, press the START button.
PLAYSTATION® 2
INSTALLATION ON PLAYSTATION® 2
1. Connect the receiver's PS2 Gameport connector (9) to port number 1 on your console.
2. Switch on your console.
3. Switch on your gamepad using the POWER ON switch (13).
4. Start up your game.
You are now ready to play!
ATTENTION: NEVER CONNECT THE USB CABLE (10) TO YOUR PLAYSTATION® 2
(to avoid the risk of damaging your gamepad or your console)
2/6