Operation; Before Initial Operation; Emperature Setting - Pkm GS 165-2 Bedienungsanleitung

23. Open the door of the appliance and reinstall the previously removed door trays
/ glass shelves / drawers / wire shelves, etc
24. Close the door and connect the appliance to the mains again.
NOTICE! Adjust the door properly. The seal must close properly.

4. Operation

WARNING! To disconnect the appliance from the mains, you must
unplug the appliance or use a cut-off device.

4.1 Before initial operation

WARNING! While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD! RISK OF INJURY!
NOTICE! Leave the appliance in an upright position for at least 4 - 6 hours
before you connect it to the mains to ensure, that the oil has flowed back
into the compressor.
NOTICE! If you use the appliance for the first time or the appliance has
been disconnected from the mains for a longer period of time, allow the
appliance to cool down for approx. 3 - 4 hours on the highest thermostat
setting [s. chapter 4.3 T
before you place any fresh or frozen food in the appliance. If you place
food in the appliance before it has reached its normal operating
temperature, the food can thaw and / or spoil.
1. Remove all packaging materials.
2. Adjust the feet and clean the appliance; see also chapters « L
« C
LEANING AND MAINTENANCE
3. Do not start the appliance immediately after installation. Wait at least 4 - 6 hours
to ensure proper operation.
4. Connect the appliance to the mains properly.
5. The setting of the freezer temperature can be adjusted manually by turning the
thermostat to the desired setting.; s. chapter 4.3 T
(
THERMOSTAT SETTING
6. The noise generated by the compressor and the gases / liquids of the appliance
is normal.
Depending on model.
18

EMPERATURE SETTING

».
).
~ 70 ~
18
.
(
THERMOSTAT SETTING
EMPERATURE SETTING
)]
» and
EVELLING