Operating Instructions - TensCare TENS One Gebrauchsanweisung

10.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit ON, rotate on
of the control knobs clockwise
until you hear a click, the LED
indicator will light up (green colour).
To turn the unit OFF, rotate one of the
control knobs anti-clockwise until you
hear a click, the display will stop.
The unit will start with the mode you
used last.
Note: Always check unit is
OFF before
removing electrode pads.
MODE CONTROL
The button marked MODE is
MODE
the mode control. The TENS
One has three different modes. When
the unit is first
automatically enters mode N.
Each time you press and release the
MODE button, the mode changes and
the letter is shown on the LCD.
Before changing the mode, it is strongly
recommended to bring the intensity
back to zero.
Each time you change the mode, the
strength level reverts back to zero for
three second before ramping back up to
the previous level of intensity.
TREATMENT TIMER
The TIMER button can be
TIMER
used to set the session
duration. Press and release to change
the session time. You can set session
applying or
switched on it
16
times of C (Continuous) or 15, 30, 45,
60 or 90 minutes.
The LCD shows the session duration
next to the min symbol. The unit
automatically counts down the minutes
set, once it reaches 0 the display will
flash until the device is manually
switched off.
PULSE RATE CONTROLS
To increase the frequency (or
pulse rate), rotate the pulse rate
knob clockwise. To decrease, rotate the
knob anti-clockwise.
PULSE WIDTH CONTROLS
To increase the pulse width,
rotate the pulse width knob
clockwise. To decrease, rotate the knob
anti-clockwise.
STRENGTH CONTROLS
On the top of the unit, there
are two rotating control knobs.
The left-hand knob change
strength in the left-hand lead and the
right-hand knob change the right-hand
lead.
To increase the strength, turn the knobs
clockwise.
To decrease the strength, turn the
knobs counter-clockwise.
The strength levels are shown on the
LCD.
The unit has 20 levels of strength, each
step is 4mA. You may feel nothing over
the first few levels. Continue turning the
knobs carefully until the sensation is
strong but comfortable.
increases during use may be necessary
Further