Brock WK 2106 LL Bedienungsanleitung Seite 8

GB
To protect from electrical hazard，do not immerse this kettle，power base or cord set in any
liquid．
Use the kettle only with the supplied base unit．Do not use the base unit for other purposes．
To protect against fire，do not operated in the presence of explosive and/or flammable fumes．
While the water doiling or in the short time after the water boils, please be sure that don't
attempt to open the cover for avoid the steam scalding your hand．
Please avoid the liquid sprinkling in the LCD board and the pressed key place in the operating
process. Because the water possibly can plunge in the product, causes the function to be unusual.
Please do not have to add surpasses the maximum water volume the water, because this has the
possibility to damage the product, causes the product movement to appear exceptionally．
Please regular clean descale or pot bottom residuum, because this possibly can affect the normal
use of the product．
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
This appliance should not be used by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have are
supervised by the person who is responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance
INSTRUCTION FOR USE
1．Before use preparatory work:
Before first use，fill the kettle with clean water to maximum capacity and boil．Discard the
water and repeat the process. The kettle should always be unplugged when filling or adding
water．
Fill the kettle with water to desired level．Do not overfill or there will be a risk of spillage or
spitting．The water level indicator will assist you to measure the correct amount．You can fill
the kettle via the spout or after opening the lid．Do not forget to close the lid after filling，
otherwise the kettle will not automatically switch off after use．
Do not fill with less than 0.5 liters of water（to "min" indication）to prevent the kettle running
dry while operating. Do not fill with less than 1.7 liters of water（to "max" indication）．
An automatic safety cut-out has been fitted for protection against overheating，it will operate if
the kettle is switched on when containing insufficient water．Always ensure the water inside the
kettle covers the minimum mark on the water level indicator gauge．If the automatic safety cut-
out has operated，switch the kettle off，disconnect from the power outlet and allow the kettle
to cool down for 5 to 10 minutes. The refill with and switch on，the kettle will work as normal.
After boiling, the kettle switches off automatically. Disconnect the kettle from the mains
electricity supply.