Loosening The Harness - Kinderkraft COMFORT UP Bedienungsanleitung

Now thread the small belts of the chest pads and harness into the corresponding belt
Step 5:
slots (Fig. 4.1-6).
Slide both of the chest pads in the chest pad connector, and slide the harness straps in
Step 6:
the harness connector.
Ensure that the belt is positioned correctly in the belt slot and not twisted.
4.2 Securing the child car seat (group
Place the child safety seat on the vehicle's seat which is fitted with 3-point safety belts
Step 1:
ensuring it is firmly pressed against the car seat backrest (Fig. 4.2-1).
Pull out the vehicle belt, thread the belt tongue (incl. vehicle belt) through the Adult
Step 2:
belt route slot (N) to the rear and through the backrest, through the other Adult belt route
(N) (on the buckle side) and allow it to lock in place. You will hear "click"
Place the vehicle lap belt under the armrest on both sides
Step 3:
belt on the vehicle buckle side through the red belt guide under the armrest
sure adult belt has not become twisted (Fi
Press your knee on the child car seat and pull the diagonal belt along the direction as
Step 4:
the picture shows (Fi
shoulder belt in the direction of the automatic roll-up as possible (Fi
The satisfactory position of the adult safety-belt relative to the child car seat is as the
6. You can contact the child car seat manufacturer if in doubt about this point.
To release your child seat following the above instructions in reverse
Ensure that each part of the belt is tightened as possible. Make sure all the belts' position is
right and they has not become twisted. Also check that the cover is not impeding the
movement or fit of the belt webbing in any

4.3 Loosening the harness

• The harness is slackened by pressing the lever (under the seat cover) on the front of the
seat (H).
• Press down on the label marked
hand. Pull the shoulder straps towards you to loosen the harness (Fig. 4.3).
4.4 Securing the child with the harness
• Firstly, adjust the
• Loosen the harness (see point 4.3), open the buckle (4.4.1) and place them down sideways.
• Seat your child in the child car seat
• Fasten the buckle (4.4.1).
• Pull the shoulder straps upwards to remove the slack from the lap sections of the harness
then pull the adjuster strap (I) until the harness is fully tightened (Fig. 4.4).
• The harness should be adjusted as tightly as possible without causing discomfort to your
child .
I)
g. 4.2-6). Make sure that belt has not
'Press"
shoulder belts height (see point 4.1), proceed as follows:.
.
EN
g. 4.2-5).
way.
as you grip the two shoulder straps with your other
Place both shoulder belts over your child's shoulders.
24
(Fig. 4.2-2,
. Pull the vehicle diagonal
(Fig.
loosened. Tighten the diagonal
g. 4.2-6).
order.
slot
Fig. 4.2-3).
4.2-4). Make
Fig. 4.2-