LENCO DIR-260 Bedienungsanleitung Seite 28

When PBC Wlan setup is selected, the unit will scan the available wireless network.
Refer to page 6.
When View settings is selected, you can check the "Active connection",
"MAC address", "Wlan region", "DHCP", "SSID", "IP address", "Subnet mask", "Gateway
address", "Primary DNS" and "Secondary DNS".
When Wlan region is selected, refer to page 6.
2. In System settings menu, if Time/Date is selected, the screen will appear as below
3. In System settings menu, if Language is selected, select one to set the interface
language.
4. In System settings menu, if Factory Reset is selected, set it to "YES" to proceed, set it to
"NO" to cancel factory reset.
5. In System settings menu, if Setup wizard is selected, you can confirm if start setup now.
6. In System settings menu, if Info is selected, you can check the "SW version", "Radio ID"
and "Friendly Name".
7. In System settings menu, if Backlight is selected, the screen will appear as attached
images.
If Timeout is selected, you can set the backlight of the screen of Timeout to On, 10 sec,
20 sec, 30 sec, 45 sec, 60 sec. 90 sec, 120 sec or 180 sec.
If On level is selected, you can set the backlight of the screen of Power On level to High,
Medium or Low.
If Dim level is selected, you can also set the backlight of the screen of Standby Level to
High, Medium or Low.
28