Prebena PKT-8-PR100 Originalbetriebsanleitung Seite 131

The insertion depth depends not only on the set insertion depth, but
also on the hardness and thickness of the material.
▶ Make certain there is no one behind the material.
▶ Set a small insertion depth for testing.
▶ Check the function of the fastener driving tool with single
triggering.
Triggering the fastener driving tool one time
To trigger the fastener driving tool one time, follow these steps:
▶ Choose triggering process "Single triggering with safety follow-up"
by pressing the "T" button (trigger one time) on the control panel
(see page 28). The blue LED is lit.
▶ Place the triggering safety device of the fastener driving tool on
the material and press the fastener driving tool against the
material.
▶ Press the triggering mechanism all the way down.
✓ The nail is driven into the material.
▶ Release the triggering mechanism.
▶ Lift the fastener driving tool up off the material.
WARNING
Danger of injury due to nail driven in too deep, nail
slipping or recoil.
▶ Use the fastener driving tool only for the
material specified in this operating manual (see
Designated use, page 9).
▶ Make certain the insertion depth is not greater
than the thickness of the material.
▶ Press the fastener driving tool firmly on the
material while triggering.
▶ Make certain the material is not too hard.
Operation
51