Prebena PKT-8-PR100 Originalbetriebsanleitung Seite 125

▶ Trigger the fastener driving tool.
▶ Check the following items:
− Triggering occurs only when the triggering safety device is
pressed in, in other words when the tool tip is firmly pressed
against the wood.
− For single triggering: The depressed triggering safety device and
the trigger button must always be moved back to the original
position to be triggered again.
− For contact triggering: While the trigger button is depressed,
every time the tool tip is pressed onto the material within 5
seconds, a nail is driven into the piece of wood.
− If the pause between contacts with the wood is more than
5 seconds, single triggering is set automatically.
▶ If the insertion depth is not correct, change the setting on the
adjusting wheel (see page 47).
▶ Run a test on a piece of wood again and check the insertion
depth.
✓ If all functions are performed correctly, you can use the
fastener driving tool.
Before operation
45