Miele SPQL0 Gebrauchsanweisung Seite 76

en
Problem
The robot vacuum
cleaner does not return
to the base station after
vacuuming.
The robot vacuum
cleaner is not charging.
76
Cause and remedy
It had started vacuuming from somewhere in the
room.
 The robot vacuum cleaner will return to its starting
point.
There is insufficient light for the robot vacuum
cleaner to navigate.
 Provide sufficient lighting.
The base station is not connected correctly.
 Connect the base station exactly as described in
these operating instructions, see section "Connec-
tion" – "Connecting the base station".
The signal between the infrared transmitter on the
base station and the robot vacuum cleaner is broken.
 Clean the front of the base station and the front of
the robot vacuum cleaner carefully with a soft, dry
cloth and make sure that no items disrupt the sig-
nal.
Obstacles on the floor which is to be vacuumed can
impede navigation.
 Watch the robot vacuum cleaner during vacuum-
ing.
 Remove any problematic obstacles.
 Section off the problematic area with the magnetic
strip.
 Reduce the robot vacuum cleaner's maximum
crossing over height, see section "Use" – "Redu-
cing the maximum crossing over height".
The base station is not connected correctly.
 Connect the base station exactly as described in
these operating instructions, see section "Connec-
tion" – "Connecting the base station".