Attaching And Removing The Running Wheels - Stihl MH 700 Gebrauchsanleitung

6 Assembling the Cultivator
► Tighten locking screws (4).
► Assemble hoe halves (5 and 6) so the bores align.
► Insert bolt (7) into the bores.
► Place washers (8) and spring washer (9) on bolt (7).
► Screw on nut (10) and tighten firmly.
► Push hoes (11) onto drive shaft (3) so the bores align.
► Push folding retainers (12) through the bores in drive
shaft (3) and close the securing clips.
Hoes (11) are secured.
6.1.2 Removing the Hoes
► Stop the engine.
► Pull out the folding retainers.
► Remove the hoes.
► Push the folding retainers through the bores in the drive
shaft.
The folding retainers are kept in place.
6.2

Attaching and Removing the Running Wheels

6.2.1 Attaching the Running Wheels
► Stop the engine.
0478-404-9604-A
► Loosen bolts (1) on running wheel (2).
► Remove washers (3), spring washers (4) and nuts (5).
► Place axle mount (6) on running wheel (2) so the bores
align.
► Insert bolts (1).
► Place washers (3) and spring washers (4) on bolts (1).
► Screw on nuts (5) and tighten firmly.
Axle mount (6) must not be dismantled again.
► Push running wheels (7) onto drive shaft (8) so the bores
align.
English
55