Operation; Maintenance; Optional Accessories - Makita 1806B Bedienungsanleitung

Connecting a vacuum cleaner
NOTE: In some countries, the nozzle may not be
included in the tool package as standard accessory.
► Fig.7: 1. Nozzle 2. Vacuum cleaner
For tool with nozzle
Connect a hose of the vacuum cleaner to the nozzle.
For tool without nozzle
1. Remove the chip cover from the tool.
2. Install the nozzle on the tool using the screws.
► Fig.8: 1. Nozzle 2. Screwdriver
3. Connect a hose of the vacuum cleaner to the
nozzle.
Nozzle cleaning
Clean the nozzle regularly.
Use a compressed air to clean the clogged nozzle.

OPERATION

WARNING:
To reduce the risk of injury to
persons, do not operate without nozzle or chip
cover in place.
Planing operation
► Fig.9: 1. End 2. Start
First, rest the tool front base flat upon the workpiece
surface without the blades making any contact. Switch
on and wait until the blades attain full speed. Then
move the tool gently forward. Apply pressure on the
front of tool at the start of planing, and at the back at the
end of planing. Planing will be easier if you incline the
workpiece in stationary fashion, so that you can plane
somewhat downhill.
The speed and depth of cut determine the kind of finish.
The power planer keeps cutting at a speed that will not
result in jamming by chips. For rough cutting, the depth
of cut can be increased, while for a good finish you
should reduce the depth of cut and advance the tool
more slowly.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
Sharpening the planer blades
Always keep your blades sharp for the best perfor-
mance possible. Use the sharpening holder to remove
nicks and produce a fine edge.
► Fig.10: 1. Sharpening holder
First, loosen the two wing nuts on the holder and insert
the blades (A) and (B), so that they contact the sides
(C) and (D). Then tighten the wing nuts.
► Fig.11: 1. Wing nut 2. Blade (A) 3. Blade (B) 4. Side
(D) 5. Side (C)
Immerse the dressing stone in water for 2 or 3 minutes
before sharpening. Hold the holder so that the both
blades contact the dressing stone for simultaneous
sharpening at the same angle.
► Fig.12
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments
might present a risk of injury to persons. Only use
accessory or attachment for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• High-speed steel Planer blade
• Sharpening holder assembly
• Blade gauge
• Edge fence (Guide rule)
• Extension guide set
• Dressing stone
• Nozzle assembly
• Hex wrench
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
7 ENGLISH