Troubleshooting - ZANKER KEAK82FR Benutzerinformation

7. Set the temperature regulator to obtain the
maximum coldness and run the appliance for at
least 3 hours using this setting.
Only after this time put the food back into the freezer
compartment.
Cleaning the air channels
1. Remove the plinth (A), then the ventilation grid (B).

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
Acoustic or visual alarm is on.
The compressor operates continual-
ly.
12
C B A
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on.
The temperature in the appliance is
too high.
The door is left open.
Temperature is set incorrectly.
2. Clean the ventilation grid.
3. Carefully pull the air deflector out (C), checking that
there is no water left from the defrosting.
4. Clean the lower part of the appliance with a
vacuum cleaner.
Period of non-operation
When the appliance is not in use for long period, take
the following precautions:
1. Disconnect the appliance from electricity supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent unpleasant
smells.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
Check if the appliance stands sta-
ble.
Refer to "Door Open Alarm" or
"High Temperature Alarm".
Refer to "Door Open Alarm" or
"High Temperature Alarm".
Close the door.
Refer to "Control Panel" chapter.
Solution