Troubleshooting - ZANKER KTAK14FS1 Benutzerinformation

3. Leave the door open. Protect the floor
from the defrosting water e.g. with a cloth
or a flat vessel.
4. In order to speed up the defrosting
process, place a pot of warm water in the
freezer compartment. In addition, remove
pieces of ice that break away before
defrosting is complete.
5. When defrosting is complete, dry the
interior thoroughly.
6. Switch on the appliance and close the
door.
7. Set the temperature regulator to obtain
the maximum coldness and run the
appliance for at least 3 hours using this
setting.

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
Acoustic or visual alarm is on.
The compressor operates contin‐
ually.
14 ENGLISH
Only after this time put the food back into the
freezer compartment.
7.5 Period of non-operation
When the appliance is not in use for long
period, take the following precautions:
1. Disconnect the appliance from electricity
supply.
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent
unpleasant smells.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on.
The temperature in the appliance
is too high.
The door is left open.
Temperature is set incorrectly.
Many food products were put in
at the same time.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap‐
pliance to the mains socket. Con‐
tact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door Open Alarm" or
"High Temperature Alarm".
Refer to "Door Open Alarm" or
"High Temperature Alarm".
Close the door.
Refer to "Control Panel" chapter.
Wait a few hours and then check
the temperature again.