Scheduled Maintenance Table; Main Broom Height Check And Adjustment - Nilfisk FLOORTEC R 360 B Bedienungshandbuch

USER MANUAL
ENGLISH

SCHEDULED MAINTENANCE TABLE

Procedure
Battery fluid level check
Side and main broom height check and
adjustment
Dust filter cleaning and integrity check
Skirt height and operation check
Filter shaker operation check
Hood safety switch operation check
Main broom drive belt visual inspection
Nut and screw tightening check
Service and parking brake check and
adjustment
Main broom drive belt replacement
Main motor and drive system motor carbon
brush check and replacement
(*): For the relevant procedure, see the Service Manual.
(1): And after the first 8 running-in hours.
MAIN BROOM HEIGHT CHECK AND
ADJUSTMENT
NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
1. Check that the main broom is at the correct height
from the ground, according to the following
procedure:
– Drive the machine on a level ground.
– Keep the machine stationary and rotate the main
broom for a few seconds.
– Stop and lift the main broom, then move the
machine.
– Check that the main broom print (1, Fig. D), along
its length, is from 2 to 4 cm wide.
If the print (1) is not within specifications, it is
necessary to adjust the broom height, according
to the procedure shown in step 2.
2. Drive the machine on a level ground and engage the
parking brake (6 and 7, Fig. C).
3. Turn the ignition switch (2, Fig. B) to "0" position.
4. Loosen the knobs (1, Fig. E) on both sides of the
machine.
12 FLOORTEC R 360 B
Every 10
On delivery
hours
 
 



5.
6.
7.
Every 50 Every 100
hours hours


(*)

(*)

(*)

(*) (1)

(*)
Operating on the knobs (1, fig. E) move, on both sides
of the machine, the broom height variation indicator
(2) as necessary and then screw down the knobs (1).
NOTE
The indicator (2) must be at the same
position on both sides of the machine; the
maximum difference allowed is 2 notches
to obtain the print (1, Fig. D) from 2 to 4 cm
as shown in step 1.
Perform step 1 again to check that the main broom is
at the correct height from the ground.
When the broom is too worn and can no longer be
adjusted, replace it according to the instructions in the
following paragraph.
CAUTION!
An excessive print (larger than 4 cm) of the
main broom can lead to the machine
malfunction and the overheating of the
moving parts, thus reducing machine life.
Pay careful attention when performing the
above-mentioned checks, and always use
the machine according to the indicated
conditions.
146 2596 000(3)03-2016
Every 200 Every 400
hours hours

(*)

(*)