ZANKER KDT10053FK Benutzerinformation Seite 19

Problem and alarm code
The temperature of the water inside
the appliance is too high or malfunc-
tion of the temperature sensor oc-
curred.
• The lights related to the pro-
gramme buttons flash 6 times
intermittently.
• An acoustic signal sounds inter-
mittently.
Technical malfunction of the appli-
ance.
• The lights related to the pro-
gramme buttons flash 12 times
intermittently.
• An acoustic signal sounds inter-
mittently.
The level of water inside the appli-
ance is too high.
• The lights related to the pro-
gramme buttons flash 15 times
intermittently.
• An acoustic signal sounds inter-
mittently.
The appliance stops and starts
more times during operation.
The programme lasts too long.
Small leak from the appliance door.
The appliance door is difficult to
close.
Rattling or knocking sounds from
the inside of the appliance.
The appliance trips the circuit-beak-
er.
Possible cause and solution
• Make sure that the temperature of the inlet water does not exceed 60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right height above the
floor. Refer to the installation instructions.
• It is normal. It provides optimal cleaning results and energy savings.
• If the delay start option is set, cancel the delay setting or wait for the end
of the countdown.
• Activating Extra power increases the programme duration.
• The appliance is not levelled. Loosen or tighten the adjustable feet (if ap-
plicable).
• The appliance door is not centred on the tub. Adjust the rear foot (if appli-
cable).
• The appliance is not levelled. Loosen or tighten the adjustable feet (if ap-
plicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Refer to basket
loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all the appliances in
use. Check the socket amperage and the capacity of the meter or turn off
one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised Service
Centre.
19