Stahl 9441-Serie Betriebsanleitung Seite 63

Changing IP address
LCD display
CPU 0-0: Status
NoDataExch
CPU 0-0:Address
< >
IpAdr < >
192. 23.121.7
IpAdr change
192 23.121. 7
IpAdr change
192 23 121. 7
accept changes ?
no yes < >
169128 / 944160310050
2020-08-25·BA00·III·en·08
Settings
 Press the [Enter] key twice to switch from the system level to the
information/service level.
 Press the [Enter] key once if the display shows
"CPU 0-0: primary; 9441/12-00-00" in order to switch from the
12309E00
system level to the information/service level.
The following display appears (shown on the left).
 Press the ◄ or ► key until the following display appears
(shown on the left).
12310E00
 Press the [Enter] key.
The following display appears (shown on the left).
12311E00
 Press the [Enter] key.
The first address block is marked.
12330E00 The following display appears (shown on the left).
 Press the ◄ or ► key until the required value is set.
Press and hold the button to change the value quickly
(continuously).
 Press the [Enter] key.
The change to the first address block is applied.
12277E00 The second address block is marked.
The following display appears (shown on the left).
 Change the second to fourth address blocks in the same way as the
first address block.
 Press the [Enter] key.
The following display appears (shown on the left).
12313E00
 Press the [Enter] key to confirm the change to the address or
press the [ESC] key to cancel the change to the address.
The display switches back to the main menu in the information/
service level.
Parameterization and Commissioning
Ethernet CPU module and
power module for Zone 1/Class I, Div.1
Series 9441, Series 9444, Series 9492
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
21