Migatronic Sigma Select ROBO 300 Betriebsanleitung Seite 12

Connection and operation
7
8
2
5
6
9
10
Software update
• Insert the SD-card
• Turn on the machine
• Wait until the unit indicates
that the update is complete
• Turn off the machine and
remove the SD card.
• The machine is now ready
for use.
New software will be loaded into power source and all
connected units.
The software can be downloaded from http://migatronic.com to
an SD card. The file system of the SD card must be formatted to
FAT32.
IMPORTANT:
Save the software in the //MIGA_SW/SIGMA/ file structure.
Licence SW
If you purchase additional licences for programs or special
funtions, load the MigaLic.dat files like the software packages.
Note! Create a backup of the files.
The MigaLic.txt file contains information about licence number
and licences saved on SD card.
7
4a
4b
5
6
1. Mains connection
1
2. Power switch on/off
3
3. Connection of shielding gas
4a. Connection of cooling hose, return (red)
4b. Connection of cooling hose, flow (blue)
5. Dinse connection
GAS
6. Dinse connection
2-6 bar
7. CAN connection (Remote, RCI4, RWF30)
8. Fieldbus module
9. Refill of cooling liquid
F
10. Cooling liquid level control (Min/Max)
Power
F
F
11. Assembly plate
11
12
-
+