Error Message List - JVC KW-V40BTE Bedienungsanleitung

REFERENCES REFERENCES

Error message list

If an error occurs while using the unit, a message
appears. Take appropriate action according to the
following message/remedy/cause list.
"No Signal":
• Start the playback on the external component
connected to the AV-IN1 terminal.
• Check the cords and connections.
• Signal input is too weak.
" MISWIRING Check wiring connection then reset
unit"/" WARNING Check wiring connection then
reset unit":
• A speaker cord has shorted or it has come in to
contact with the car chassis. Wire or insulate the
speaker cord as appropriate, then reset the unit.
(Pages 3 and 46 )
"Parking Brake ":
• No playback picture is shown when the parking
brake is not engaged.
"Eject Error"/"Loading Error":
• Eject the disc forcibly. (Page 3)
"Restricted Device ":
• Check whether the connected iPod/iPhone is
compatible with this unit. (Page 51)
"USB Device Error":
• The USB power voltage is abnormal.
• Turn off and turn on the unit.
• Connect another USB device.
"Connection Error":
• The device is registered but the connection has
failed. Connect the registered device. (Page 27)
"Please Wait...":
• The unit is preparing to use the Bluetooth
function. If the message does not disappear, turn
off and turn on the unit, then connect the device
again (or reset the unit).
"No Voice Device":
• The connected mobile phone does not have a
voice recognition system.
"No Data":
• No phone book data is contained in the connected
Bluetooth phone.
"Initialize Error":
• The unit has failed to initialize the Bluetooth
module. Try the operation again.
"Dial Error":
• Dialing has failed. Try the operation again.
"Hung Up Error":
• The call has not ended yet. Park your car, and use
the connected mobile phone to end the call.
"Pick Up Error":
• The unit has failed to receive a call.
ENGLISH 53