Proper Measurement Position - Riester ri-champion smartPRO Gebrauchsanleitung

Pile Side Material
Sewn Hook Material
D-Ring
2-3 cm Main Arterles
The range index of cuff should fall
within this range

PROPER MEASUREMENT POSITION

3. Stretch your left (right) arm in front of you
with your palm facing up. Slide and place the
cuff onto your arm with the air tube and artery
mark region toward the lower arm. Wrap and
tighten the cuff above your elbow. The bottom
edge of the cuff should be approximately
0.8" to 1.2" (2 cm to 3 cm) above your elbow.
Align the tube over the main arteries on the
inside.
4. Leave a little free space between the arm and
the cuff; you should be able to fit two fingers
between them. Clothing must not restrict
the arm. Remove all clothing covering or
constricting the measurement arm.
5. Press the hook material firmly against the pile
material. The top and bottom edges of the
cuff should be tightened evenly around your
upper arm.
1. Sit down for at least 10 minutes before
measuring.
2. Place your elbow on a flat surface. Relax
your hand with the palm facing up.
3. Make sure the cuff is about the same height
as the location of your heart. Press
Remain still and do not talk or move during
the measurement.
WARNING
If the cuff is relatively lower (higher) than the
heart, the obtained blood pressure value could
be higher (lower) than the actual value. A 15
cm difference in height may result in an error
around 10 mmHg.
10
.