Bosch Sensixx'x TDi90 EasyComfort Gebrauchsanleitung Seite 20

25ml
20
BO S C H
C "Calc'nClean" function
The "Calc'nClean" function helps to remove scale particles
out of the steam chamber.
If the water in your area is very hard, you may use this
function approximately every two weeks.
1 Unplug the iron from the mains socket.
Tip: For deep descaling, it is recommended to use the
descaling liquid (see "Accessories" section). This procedure
should be carried out every 3 months.
Pour a measure (25 ml) of the descaling luid into the water
tank.
45º
2 Fill the water tank up to the level mark for maximum
illing.
3 Plug in the iron.
4 When the lamp "TempOK" (12) remains lit continuously,
unplug the iron (very important!).
5 Hold the iron over a sink.
6 Press the "clean" button (11) and shake the iron
back and forth keeping it in a horizontal position until
approximately one third of the water capacity of the tank
is evaporated. Boiling water and steam will come out,
carrying scale or deposits that might be there.
7 Release the "clean" button, and gently shake the iron for
some seconds.
8 Repeat steps 6 and 7.
9 Check carefully that the water tank is empty (very
important!).
10 Plug the iron in and heat it up again until the remaining
water has evaporated.
11 Unplug the iron and let the soleplate cool down. Wipe
the soleplate with a damp cotton cloth only.