Installation; Indicator Of Temperature - Sharp SJ-F800SPBK Bedienungsanleitung

INSTALLATION

WARNING
Do not install the refrigerator in a damp or wet
■
location as this may cause damage to the
insulation and a leak. Condensation may also
build on the outer cabinet and cause rust.
1
Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum required space for
installing the refrigerator. It differs from the space in
the measurement condition of the amount of power
consumption.
• It is possible to use the refrigerator with a less amount
of power consumption by keeping greater space.
• If using the refrigerator in the space below dimension
of the figure, it may cause the temperatures in the unit
to rise, loud noise, and failure.
90mm
or more
60mm 60mm
or more or more
2
Using the two front
adjustable feet, ensure that
the refrigerator is positioned
firmly and level on the floor.
Adjustable foot
3
When right and left doors are not properly aligned,
adjust using the adjustable feet.
When the left door is raised. When the right door is raised.
Lower the right side. Lower the left side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
Remove the 4 screws
of the cabinet lower
part, and then set the
foot cover (supplied
inside the refrigerator
compartment) with
removed 4 screws.
Foot cover
NOTE
•
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
Do not place directly on the ground.
Provide suitable stand.
•
To insert the power plug when the door is opened, door
alarm sounds but it is not abnormal. This sound stops when
closing the door.
When transporting
• Using the casters, it is possible to move back and forth.
• Carry the refrigerator by holding the handles located on
the rear and bottom.
Casters
Before using your refrigerator
60mm
or more
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
INDICATOR OF
TEMPERATURE
1500 mm
This refrigerator is provided with a indicator of temperature
in the refrigerator compartment to allow you to control the
average temperature in the coldest zone.
Coldest zone
The symbol indicates the coldest zone in the
refrigerator compartment.
(The door pocket positioned at the same
height isn't the coldest zone.)
Checking the temperature in the
coldest zone
You can carry out regular checks to ensure the
temperature in the coldest zone is correct and, if
necessary, adjust the refrigerator temp. control.
To maintain a correct temperature inside the appliance,
check that the indicator of temperature is always BLUE.
If the indicator of temperature turns WHITE, the
temperature is too high; in this case, increase the
refrigerator temp. control setting and wait for 6 hours
before checking the indicator of temperature again.
Screw
(4 screws)
NOTE
•
The internal temperature of the refrigerator depends on
various factors such as the ambient temperature of the
room, the amount of food stored and the frequency of door
opening.
• When fresh food has been introduced or the door has been
left open for some time, it is normal for the indicator of
temperature to turn WHITE.
rear
BLUE WHITE
Temperature too high,
Correct setting
adjust the refrigerator temp.
control.
GB
E
I
bottom
F
P
GR
D
NL
Symbol
PL
H
RO
CZ
SK
LT
LV
EST
SLO
UA
BG
3